This module allows for a line of holes to be placed horizontally on the part for drawer slide attachment. The part, however, can be in any orientation. This module is also flexible enough to be used for knock down fittings by selecting different surfaces and different reference points. The offset point can work from any location. The most frequent being the front bottom corners of a drawer, a corner of a drawer face, and the top, bottom, or center of a vertical.  In order to save on machining time, only those holes that need to be drilled for the specific piece of hardware are bored. If you do not know which hardware you may be using, an entire line can be generated which will fit all of the 32mm system slides. You can start the holes with any setback you would like. A 37mm would be suitable for a standard full overlay cabinet, however it is just as easy to make it a 12mm setback if a 25mm face frame is to be used. When using the program, please make sure to read all the prompts as they can sometimes change depending upon any previous machining that has been done on the part.